CRRM1700 Raymond Grinding Mill

Introduction to CRRM1700 Raymond Grinding Mill

The CRRM1700 Raymond Gringding Mill  is adept at processing non-flammable and non-explosive ores with a Mohs hardness of 7 or below and a moisture content below 8%, such as limestone, marble, calcite, feldspar, barite, dolomite, maifanite, granite, bentonite, kaolin, bauxite, gypsum, talc, fluorite, coal gangue, iron oxide red, and iron ore, among others. It can efficiently grind and process these materials. The equipment allows for flexible adjustment of the final product particle size, ranging from 40 to 400 mesh. The maximum feed size it can accept is 30mm, with a 325 mesh pass rate of ≥90%, ensuring uniform particle size. Its production capacity falls within an efficient range of 6 to 28 tons per hour.

Capacity：6-28t/h

Fineness：40-400mesh

Maximum feed size：30mm

Case Study of CRRM1700 Raymond Grinding Mill

Limestone Processing Case: A large building materials enterprise has long been committed to the production of building materials such as cement and lime. After various inspections and comparisons, the enterprise chose the CRRM1700 Raymond Mill.

After using the CRRM1700 Raymond Mill to process limestone, the output has been significantly increased. When using the old equipment originally, the hourly output was only about 5 tons. After replacing the equipment, the output has been stably maintained at 18 tons per hour, and the production capacity has increased by nearly three times. In terms of the finished product particle size, the expected goal has also been achieved. The particle size of the produced limestone powder is mainly concentrated at 325 mesh, with a passing rate of 92%, fully meeting the requirements of downstream industries such as cement production for the particle size of limestone powder. Due to the energy-saving advantages of the CRRM1700 Raymond Mill, the energy consumption cost has been reduced by about 25%. The equipment maintenance cost has also decreased, saving about 100,000 yuan in maintenance costs each year.

Calcite Processing Case: An enterprise specializing in the production of chemical raw materials mainly produces calcite fillers for plastics and rubbers. In order to enhance the competitiveness of its products in the market, the enterprise decided to upgrade its calcite powder grinding equipment. After the CRRM1700 Raymond Mill was put into use, it has achieved remarkable results in terms of product quality improvement. The produced calcite powder has a uniform particle size and good dispersibility. When used in the production of plastics and rubbers, it can better integrate with the matrix materials, increasing the toughness of plastic products by 20% and the wear resistance of rubber products by 15%. In terms of production efficiency, the small powder grinding equipment previously used by the enterprise had an hourly output of only 3 tons, while the CRRM1700 Raymond Mill can reach an hourly output of 10 tons, greatly improving the production efficiency and meeting the enterprise's growing order demand.

Parameter comparison table of CRRM Raymond Grinding Mill

* The above data is for reference only. For detailed information, please contact Cronus.

CRRM1700 Raymond Grinding Mill Customer Site